I had previously been running nas4free 9.x on the SSD without issue but felt it was time for a change to freenas. The machine has 16gb of ram and an I7 circa 2013 motherboard so far from "junker" if not cutting edge. The output of gpart show after the install (if I drop to a shell is): ![]() ![]() Each install has been from a fresh install onto a virgin ssd. formatted No Solaris fdisk partition found. I have also tried dropping to a shell after install and typing:Įach time I still get the same error "active partition not set".īetween each install I have used Active KillDisk to erase the SSD and also tried re-downloading and Killdisking the USB i have used for install. The Solaris partition must be made the active partition on the disk. I have tried with UFEI in LEGACY and AUTO mode in my computer but have no luck with either. Install completes without issue but when I restart I get the following error: USB disc created using rufus and boots without issue. There are also 2 1TB discs that I plan to use for RAID1 in the machine. ![]() If not, mark the proper partition as active partition so that the BIOS could find your operating system. The SSD is 8gb (so close to the minimum size). If system not found error still occurs, restart to the burned disk again and go to Disk Image & Clone to check whether the Active partition setting is right. iso via a USB to an internal SSD hard drive. I am attempting a fresh install of freeNAS 9.10.1-U3 from an.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |